RG-200 Rigger Level 1 – Cincinnati

Course Name: Rigger Level I
Course #: RG-200
Course Length (Days): 1
Who Should Attend: Any person responsible for the selection, inspection and operation of rigging slings, equipment, and hardware for the purpose of attaching loads to overhead cranes and hoists including persons directing the movements of a crane.
Required for Successful Completion: Pass both a written and practical examination.
Course Description: The information presented in this course teaches individuals the Occupational Safety and Health Administration §1910.184 regulations and applicable ASME B30 standards.
Topic covered: Rigging Terminology & Definitions

OSHA & National Consensus Standards Overview

Estimating Load Weights

Hitch Types

Hitch Reductions

Sling Inspection, Selection and Operation

Rigging Hardware Inspection, Selection and Operation

Center of Gravity

Load Angle Effect

Capacity Charts

ASME Hand Signals

Applicable Regulations & Standards: OSHA §1910.184 “Slings”

ASME B30.2 “Overhead and Gantry Cranes”

ASME B30.9 “slings

ASME B30.10 “Hooks”

ASME B30.20 “Below the Hook Lifting Devices”

ASME B30.26 “Rigging Hardware”

 

DOWNLOAD PDF FLYER

Cancellations
14 days prior to training will receive a full refund. If less than 14 days, a refund of 75% will be issued. If there is a no call and no show, no refund will be issued.

  • 00

    days

  • 00

    hours

  • 00

    minutes

  • 00

    seconds

Book Event

RG-200 Rigger Level 1 - Milwaukee $495.00

This training is intended for any person responsible for the selection, inspection and operation of rigging slings, equipment, and hardware for the purpose of attaching loads to overhead cranes and hoists including persons directing the movements of a crane.

Available Tickets: 100
The RG-200 Rigger Level 1 - Milwaukee ticket is sold out. You can try another ticket or another date.

Date

Dec 16 2022

Time

8:00 am - 4:00 pm

Cost

$595.00

Location

Milwaukee
REGISTER
QR Code